Lukas MSM-2D mobile control module Manual de usuario descargar pdf (Pagina 16)

9.3 Repairs

9.3.1 Replace or tighten hoses

Hose connection of the pressure and/or return line leaky or hoses defective. Tighten the

hose connections on the Mobile Selection Manifold.

(Attention! Observe tightening torque M

= 40 Nm!)

NOTE when monocouplings are used:

In order to change the hoses, the connected monocouplings must rst be removed.

ATTENTION (with monocoupling system)!

Make sure that the "T" joint of the Mobile Selection Manifold is always connected

to the "T" joint of the monocoupling!

ATTENTION (with quick-disconnect coupling system)!

The return hose on the hose line extensions (accessories) must always be

equipped with a quick-disconnect male coupling.

The supply hose line should instead be equipped with a quick-disconnect female

coupling.

9.3.2 Monocouplings

The monocouplings must be replaced if:

- exterior damage is present,

- the lock does not function,

- in the coupled and/or decoupled state, hydraulic uid continuously escapes.

WARNING / CAUTION / ATTENTION!

Couplings must not be repaired; they must be replaced with original LUKAS

parts!

During installation, tighten the coupling nuts of the hose line with a torque of M

= 40 Nm.

Procedure:

1. Pull back cover from the couplings.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Lukas MSM-2D mobile control module Manual de usuario Pagina 16