Lukas LSI Series Cutter Manual de usuario

Cutter Series LSI84150/1362-85 GBIssue 12.2005Replaces 6.2004Operating InstructionsRecycling System8 239176541110 1 Control valve with star shape

10Attention! Quick couplers partly have special functions. Therefore it is not allowed screwing them off from the hoses or to exchange them. 9

1110.2 Principles on cuttingThe blades must be applied at a right angle to the object to be cut. To enhance cutting performance, cut as close as possi

1213 Repairs13.1 GeneralServicing must be carried out only by the device manufacturer or by personnel trained by the manufacturer or the authorised L

13picture 2Clean the mechanical parts (see picture 2) with compressed air from dirt and metal chips.If the upper sealing lips of the protection boot

14Procedure:The cutter tool is in closed (retracted) position • Change of oil has to be effected at the pump.Screw off the return hose at the pump:-

15Procedure:Remove the carrying handle (held by 2 screws) • Dismount cutter blades / blade arms (see 13.3.1) • pull the faulty boot from the cylinder

14 Troubleshooting If the defects cannot be repaired, please contact an authorised LUKAS dealer or the LUKAS service department under following addre

1715 Technical data* 1MPa = 10 bar** Necessary oil quantity in the hydraulic power pack for operating the tool (Difference in quantity piston /

18 Max. Dimensions of Material LSI 230 LSI 230 LSI 235 LSI 235Type of Form Strength max. cutting Continous max. cutting Continous mat

1915.2 Central bolt / Torque15.3 Oil recommendationsFor LUKAS hydraulic devices, use mineral oil in accordance with DIN 51 524 and others

2Content page 1 Basic operation and designated use of the machine 3 2 Organizational measures 3 3 General safety instructions 4 4 Instructions

LSI_84150_1362_Ausg1205_e.indd Subject to revision© Copyright 2000 LUKAS Hydraulik GmbHLUKAS Hydraulik GmbHA Unit of IDEX Corporation Weinstraße 39,

31 Basic operation and designated use of the machine1.1 The machine has been built in accordance with state-of-the-art standards and the recognize

43 General safety instructions3.1 In the event of malfunctions, stop the machine immediately and lock it. Have any defects rectifi ed immediately.3.2

54 Instructions for maintenance and service 4.1 For the execution of maintenance and service work, tools and workshop equip-ment adapted to the task

65.1 Handling of hoses- never exceed the permissible working pressure as stated on hose and/or literature- avoid any tension (see fi gure 1) an

75.2.1 Do not go near leaks!- High pressure oil easily punctures skin causing serious injury, gangrene or death!- If injured, seek emergency medi

85.6 Examples for possible defects of hoses - Damages of the surface and the interior (e.g. chafe marks, cuts or fi ssures).- Embrittlement of the

98 Connection of the tool8.1 HydraulicTwo short hoses are fi tted to the tool; they are connected with the motor pump via a hose pair (5 m / 10 m /